Diagnostic Trouble Code Chart

1990 Mitsubishi Montero SP, StandardSECTION Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODE CHART

DTC No. Description
U0001  Bus off (CAN-C)
U0019 Bus off (CAN-B)
U0100  Engine control module CAN timeout
U0101  TC-SST-ECU CAN timeout
U0103  Shift lever CAN timeout
U0121  ASC-ECU CAN timeout
U0126  Steering wheel sensor CAN timeout
U0136  S-AWC-ECU CAN timeout
U0151  SRS-ECU CAN timeout
U0154  Occupant classification-ECU CAN timeout
U0155  Combination meter CAN timeout
U0164  A/C-ECU CAN timeout
U0168  WCM or KOS-ECU CAN timeout
U0184  Audio CAN timeout
U0195  Satellite radio tuner CAN timeout
U0197  Hands free module CAN timeout
U0245  CAN box unit CAN timeout
U1108  Excess CAN-B ECU detection
U1120  Bus line (CAN-C) low input
U1121 Bus line (CAN-C) high input
U0169 Sunroof LIN timeout < Vehicles with sunroof >
U0215 P/W SW (DR) LIN timeout
U0231 Rain light sensor LIN timeout < Vehicles with auto light function >
U1109 Column SW LIN timeout
U150B Column SW checksum error
U150C P/W SW (DR) checksum error
U1511 Sunroof checksum error < Vehicles with sunroof >
U1512 Rain light sensor checksum error < Vehicles with auto light function >
U1514 Bit error (LIN)
U1515 No-Bus activity error (LIN)
U0331 (1) ECU internal error
B1034 Ambient air temperature sensor system (short circuit)
B1035
B16A0 Taillight (RH) open circuit
B16A1 Taillight (LH) open circuit
B16A2 Blown turn-signal light (LH) bulb
B16A3 Turn-signal light (LH) short circuit
B16A4 Blown turn-signal light (RH) bulb
B16A5 Turn-signal light (RH) short circuit
B16A6 Turn-signal fuse blown
B16A7 Taillight (RH) short circuit
B16A8 Taillight (LH) short circuit
B1761 (1) VIN not recorded
B210A  +B power supply (low input)
B210B +B power supply (high input)
B222C (1) Coding incomplete
B2206 (1) Chassis number does not match
B2215 (1) ECU internal error
B2350 Lighting switch
B2351 Wiper switch
B2353  Ignition power supply (low input)
B2354 Ignition power supply (high input)
(1) : If diagnostic trouble codes No. U0331, B1761, B222C, B2206, or B2215 is set, there may be an error with the coding data stored in the ETACS-ECU.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.