Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1990MONTERO SP, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (LOCAL INTERCONNECT NETWORK (LIN) - LANCER EVOLUTION)
1990 Mitsubishi Montero SP, Standard
Section 47 (Local Interconnect Network (Lin) - Lancer Evolution)
1990 Mitsubishi Montero SP, StandardSECTION Section 47 (Local Interconnect Network (Lin) - Lancer Evolution)
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Special Tools
- Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC U0169: Sunroof LIN timeout < Vehicles with sunroof >
- DTC U0215: P/W SW (DR) LIN timeout
- DTC U0231: Rain light sensor LIN timeout < Vehicles with auto light function >
- DTC U1109: Column SW LIN timeout
- DTC U150B: Column SW checksum error
- DTC U150C: P/W SW (DR) checksum error
- DTC U1511: Sunroof checksum error < Vehicles with sunroof >
- DTC U1512: Rain light sensor checksum error < Vehicles with auto light function >
- DTC U1514: Bit error (LIN)
- DTC U1515: No-Bus activity error (LIN)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.