Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 147 Removing and installing/replacing the convertible top module
Preliminary work needed:
- Remove SIDE TRIM PANEL AT REAR RIGHT .
Removal:
Unscrew nuts (1).
Remove the equipment holder (2).
Unlock detents (1).
Pull out the convertible top module (CVM) (2).
Unlock and disconnect the connector (1) on the convertible top module (CVM) (2).
Installation:
Connect the connector (1) to the convertible top module (CVM) (2).
Join the convertible top module (CVM) (2) with the equipment holder.
Join the equipment holder (2).
Tighten down nuts (1).
Preliminary work needed:
- Install the REAR RIGHT SIDE TRIM PANEL .
Replacement:
Carry out programming/coding.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.