Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and installing battery cover
Removal:
Partially detach seal (1).
Loosen cap nuts (1).
Open locks (2) by turning them anti-clockwise.
Remove windshield panel cover (3).
Unscrew the screws (1). Remove battery cover (2).
Installation:
Thread in the battery cover (2). Tighten down screws (1). Tightening torque 61 21 6AZ .
Thread in the windshield panel cover (3).
Turn the locks (2) to the right until the stop is reached.
Tighten cap nuts (1).
Tightening torque 61 21 6AZ .
Join gasket (1).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.