Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Enter Vehicle Identification Number (Cooper, Cooper S, John Cooper Works)
Special tools required:
- 83 30 2 359 240
Read and comply with General Notes.
Preliminary work needed:
- Remove FRONT RIGHT SPRING STRUT .
Set of special tools 83 30 2 359 240 for stamping vehicle identification number consists of:
Guide plate (1)
Counter-support plate (2)
screw
Position counter-support plate on spring strut from bottom.
Position guide plate (1) on spring strut support plate from top and screw to counter-support plate.
Insert punch numbers (2) individually into guide plate and stamp vehicle identification number
Note national regulations.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.