Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2019COOPER BASE, 2D CONVERTIBLE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSFRONT AXLE - REPAIR (F57)31 00 GENERAL FRONT AXLEFRONT AXLE + STEERING: PERFORM WHEEL ALIGNMENT AFTER THE FOLLOWING REPAIR WORK (COOPER CONVERTIBLE)
2019 Mini Cooper Base, 2D Convertible, Automatic Trans
Front axle + steering: Perform wheel alignment after the following repair work (Cooper Convertible)
2019 Mini Cooper Base, 2D Convertible, Automatic TransSECTION Front axle + steering: Perform wheel alignment after the following repair work (Cooper Convertible)
Perform either the KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP or the KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLEafter the following repair work:
- Release the following screw connection
:
- Steering box to front axle support
- Tie rod end to tie rod
- Wishbone to front axle support
- Replacement of following parts
:
- Front axle carrier
- Bellows (if the tie rod end has to be screwed off)
- Steering gear
- Swivel bearing
- Tie rod end
- Tie rod
- Wishbone
- Rubber mount with holder for wishbone
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.