Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
63 11 760 Replacing FLEL control unit (Cooper Convertible)
Preliminary work needed:
- Remove HEADLIGHT - LED TECHNOLOGY .
Removal:
Loosen screws.
Remove front light electronics control unit (1) from headlight (2).
Installation:
Insert front light electronics control unit (1) into headlight (2).
Tighten the screws.
Tightening torque 63 12 3AZ .
Required follow-up work:
- Install HEADLIGHT - LED TECHNOLOGY - .
Replacement only:
Carry out PROGRAMMING/CODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.