Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2019COOPER BASE, 2D CONVERTIBLE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSBODY EQUIPMENT - TIGHTENING TORQUES (F57)5145 TRIM PANEL, INSTRUMENT PANEL
2019 Mini Cooper Base, 2D Convertible, Automatic Trans
5145 Trim Panel, Instrument Panel
2019 Mini Cooper Base, 2D Convertible, Automatic TransSECTION 5145 Trim Panel, Instrument Panel
TIGHTENING TORQUE SPECIFICATION (TRIM PANEL, INSTRUMENT PANEL)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Instrument panel trim to carrier support | F56/F55/F54/F57/F60 | Oval-head screw for plastic | 1.8 Nm | |
| Oval-head self-tapping screw | 2.4 Nm | |||
| 2AZ Support for dashboard on Firewall (in engine compartment) | F56/F55/F54/F57/F60 | 21 Nm | ||
| 3AZ Retaining bracket to tunnel/support | F56/F55/F54/F57/F60 | 21 Nm | ||
| 4AZ Support for dashboard to A-pillar | F56/F55/F54/F57/F60 | 21 Nm | ||
| 5AZ Support for dashboard to cowl cross-member | F56/F55/F54/F57/F60 | 21 Nm | ||
| 6AZ Heating and air-conditioning unit on support | F56/F55/F54/F57/F60 | Replace screws | 8 Nm | |
| 7AZ Air duct on support | F60 | 2.4 Nm |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.