Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
63 12 950 Replacing a lower holder for headlight mounting
Remove complete headlight. Refer to 63 12 001 Removing And Installing/Replacing Left Headlight (From 03/2005) , 63 12 002 Removing And Installing/Replacing Right Headlight , 63 12 010 Removing And Installing Left Headlight (Xenon Headlight) or 63 12 012 Removing And Installing Right Headlight (Xenon Headlight) .
Version with headlight cleaning system:
If necessary, release screws (1) and fold back H.P. nozzle (2).
Release screws (1) and remove holder for headlight mounting (2).
Installation:
Install holder for headlight mounting, tighten screws until hand-tight.
Install headlight and adjust BODY GAP DIMENSIONS
Tighten down screws on holder for headlight mounting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.