Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 192 Replacing Knob For Controller
For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Special Tools Required:
- 00 9 317
- 00 9 323
Attach special tools 00 9 323 and 00 9 317 as illustrated.
Lever out knob for controller (1) on both sides in direction of arrow and detach.
Installation:
Positioners (2) of knob for controller (1) must engage in openings (3) of controller (4).
For this purpose, fit knob for controller (1), turn in direction of arrow until positioners (2) engage stop.
If necessary, turn on ignition to prevent controller (4) from turning as well.
Press knob for controller (1) in middle until it engages.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.