Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4359 (AUTOMATIC TRANSMISSION - REPAIR - F32)TRANSMISSION IN GENERAL24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) N55
2013 Mini Cooper S Paceman, Automatic Trans
24 00 033 Removing and installing automatic transmission (GA8HP45Z) N55
2013 Mini Cooper S Paceman, Automatic TransSECTION 24 00 033 Removing and installing automatic transmission (GA8HP45Z) N55
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
To prevent severe damage to the engine block, the protruding threads of the transmission bolts must be strictly checked for corrosion and damage before removal
.
If there are signs of corrosion, the rust must be removed and the threads must be cleaned before removal .
Replace rusted, damaged bolts.
If there are signs of corrosion, the rust must be removed and the threads must be cleaned before removal .
Replace rusted, damaged bolts.
Failure to comply with this instruction will result in serious damage to the engine block and transmission.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.