Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4136 (INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES - F13)ELECTRIC COMPONENTS37 14 ELECTRIC COMPONENTS
2013 Mini Cooper S Paceman, Automatic Trans
37 14 Electric components
2013 Mini Cooper S Paceman, Automatic TransSECTION 37 14 Electric components
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - ELECTRIC COMPONENTS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Bracket, ride height sensor, to body | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18 | M6 | 8 Nm | |
| 2AZ | Ride height sensor holder to rear axle support | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M6 | 8 Nm | |
| 3AZ | Ride height sensor to holder | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M5 | 5 Nm | |
| 4AZ | Sensor lever, ride height sensor to jointed rod | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M6 | Replace nut | 8 Nm |
| 5AZ | Jointed rod to wishbone/trailing arm | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M6 | Replace nut | 8 Nm |
| 6AZ | Control unit, Dynamic Drive/VDM, to A-pillar (inner) | F01/F02/F06/F07/F10/F11/F12/F13/F18 | Replace nut | 3 Nm | |
| 7AZ | Valve block to body | F01/F02/F06/F07/F10/F11/F12/F13/F18 | M6 | 8 Nm | |
| 8AZ | Acceleration sensor to spring strut | F25/F26 | 8 Nm | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.