Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3893 (WHEEL AND TIRES - REPAIR)
2013 Mini Cooper S Paceman, Automatic Trans
Section 3893 (Wheel And Tires - Repair)
2013 Mini Cooper S Paceman, Automatic TransSECTION Section 3893 (Wheel And Tires - Repair)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Wheels
- 36 10 713 Checking one road wheel on balancing machine for lateral and radial runout (wheel removed)
- 36 10 715 Checking wheel rim for lateral and radial runout
- 36 10... Notes for repairing aluminium rims
- 36 10 300 Remove or install front or rear wheel
- 36 10 508 Stationary wheel balancing
- Recommendation for heating tires before removing or installing
- Disc Wheels (Rims)
- 36 00... General information on light alloy disc wheels
- 36 11 000 Initializing Run Flat Indicator (RPA)
- 36 11 503 RDC resetting
- 36 11 105 Removing and installing RDC (Tyre Pressure Control) control unit
- 36 11 105 Removing and installing RDC (Tyre Pressure Control) control unit (LOW COST)
- 36 11 115 Removing and installing/replacing RDC reception aerial
- 36 11 533 Removing and installing/replacing RDC wheel electronics (2nd generation/3rd generation)
- 36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)
- 36 11 123 Removing and installing/replacing an RDC trigger transmitter (rear)
- Tires
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.