Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2797 (FRONT AXLE - REPAIR - E90/E92 (AWD))
2013 Mini Cooper S Paceman, Automatic Trans
Section 2797 (Front Axle - Repair - E90/E92 (AWD))
2013 Mini Cooper S Paceman, Automatic TransSECTION Section 2797 (Front Axle - Repair - E90/E92 (AWD))
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- 3100 General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 3100... Front axle + steering (AWD): wheel/chassis alignment check must be carried out after the following work
- 3100... Information on replacing shock absorbers
- 6400000 Information on using cleaning agent/paints (personal protection equipment)
- 3100... Instructions (chassis components made of aluminum)
- 31.... Layout of spring strut shock absorber
- 3100 Mobile table lift
- 3100... Notes on repairing threads
- 31.... Overview of front axle (AWD)
- 31..... Overview of front differential/output shafts
- 00...... Raising vehicle with trolley jack
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 3110 Front Axle Suspension
- 3111 Front Sub-Frame
- 3112 Struts With Rubber Mounts
- 3112090 Removing and installing/replacing both compression struts (AWD)
- 3112026 Removing and installing/replacing guide joint in swivel bearing (AWD)
- 3112000 Removing and installing/replacing left or right control arm (AWD)
- 3112... Replacing guide joint on both compression struts (4WD)
- 3112148 Replacing rubber mounts on both compression struts (AWD)
- 3121 Wheel Bearings And Stub Axle
- 3131 Spring Strut
- 3100... Information on replacing shock absorbers
- 31.... Layout of spring strut shock absorber
- 3131003 Removing and installing complete front left or right spring strut (AWD)
- 5171371 Removing and installing/replacing tension strut on left or right spring strut dome
- 3131041 Replacing front left or right spring strut (AWD)
- 3133 Spring With Suspension
- 3135 Stabilizer Bar
- 3150 Front Axle Gearbox
- 3153 Differential With Bearings
- 3160 Output Shaft
- 3160... Notes on removing and installing Low Profile band clamps
- 3160... Pressing output shaft out of drive flange (wheel hub) and drawing in
- 3160000 Removing and installing/replacing left or right output shaft
- 3160530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 3151015 Replacing shaft seal for left output shaft
- 3151020 Replacing shaft seal for right output shaft
- 3160535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.