Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2512 (BODY EQUIPMENT - REPAIR)GENERAL51 00... SERVICE POSITION OF ENGINE COMPARTMENT LID
2013 Mini Cooper S Paceman, Automatic Trans
51 00... Service position of engine compartment lid
2013 Mini Cooper S Paceman, Automatic TransSECTION 51 00... Service position of engine compartment lid
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 51 0 040
- 51 2 160
- 51 2 170
- 51 2 180
- 51 2 240 see BODY EQUIPMENT - SPECIAL TOOLS .
NOTE:
Only the special tool pertaining to the model series can be selected.
SPECIAL TOOL REFERENCE
| Model series | Special tools refer to BODY EQUIPMENT - SPECIAL TOOLS for tools below. |
|---|---|
| E46, R50, R52, R53 | 51 2 160 |
| E53, E60, E61, E63, E64, E71, E81, E82, E88, E85, E86, E87, E90, E91, E92, E93 | 51 2 170 |
| E65, E66, E67 | 51 2 180 |
| E83 | 51 0 040 |
| E70 | 51 2 240 |
WARNING:
Risk of injury and damage!
Engine hood/bonnet must be held by a second person helping.
Engine hood/bonnet must be held by a second person helping.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.