64 11 845 Replacing actuator drive of defrosting flaps

2013 Mini Cooper JCW, 2D Convertible, Standard TransSECTION 64 11 845 Replacing actuator drive of defrosting flaps
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove and install housing for glovebox and cover on equipment carrier at bottom, refer to 51 45 031 REPLACING INSTRUMENT PANEL TRIM

Unlock actuator drive (1) and feed out towards side. Disconnect plug.

Fig 1: Unlocking Actuator Drive & Feed Out Towards Side
G03125426Courtesy of BMW OF NORTH AMERICA, INC.

Installation:Β 

  1. If necessary, align shaft for defrosting flaps and drive. See Fig 2.
    Fig 2: Aligning Shaft For Defrosting Flaps & Drive
    G03125427Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.