Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER JCW, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4117 (GENERAL ELECTRICAL SYSTEM - REPAIR - F13)AUXILIARY CABLE, REPAIR CABLE61 12 200 REPLACING WIRING HARNESS IN LEFT OR RIGHT FRONT DOOR

2013 Mini Cooper JCW, 2D Convertible, Standard Trans

61 12 200 Replacing wiring harness in left or right front door

2013 Mini Cooper JCW, 2D Convertible, Standard TransSECTION 61 12 200 Replacing wiring harness in left or right front door

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES .

Necessary preliminary work:

Close front side window completely
Disconnect BATTERY GROUND LEAD
Remove SOUND INSULATION IN FRONT DOOR
Remove LEFT-HAND OUTER DOOR HANDLE ON FRONT DOOR .

Unlock plug connections (1) and disconnect.

If necessary, unlock and disconnect Soft Close plug connection.

Unclip door wiring harness (2) at points (3).

Feed out door wiring harness (2).

Fig 1: Identifying Plug Connections And Door Wiring Harness Fastening Points

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure door wiring harness (2) is correctly laid.

NOTE: Front side panel shown removed for purposes of clarity.

Release screw (1), fold door wiring harness connector on A-pillar (2) downwards slightly and remove.

Unlock plug connection behind and disconnect.

Pull rubber grommet (3) in direction of arrow out of front door (4).

Fig 2: Pulling Rubber Grommet Out Of Front Door

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out door wiring harness towards front to A-pillar and remove.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.