Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
65 11 075 Removing and installing/replacing DVD changer
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT TRIM ON SIDE PANEL ON RIGHT .
- Disconnect BATTERY NEGATIVE LEAD .
- Remove LUGGAGE COMPARTMENT TRIM ON LEFT SIDE PANEL .
Release screws (1).
Pull DVD changer (2) out of fixture (3).
Unlock and disconnect associated plug connection, remove CD changer (2).
Replacement:
Release screws (1) and remove both holders (2) from DVD changer (3).
Installation:
If necessary, remove transportation lock.
Replacement:
Carry out PROGRAMMING/CODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.