Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER JCW, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3756 (GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS (ACTIVEHYBRID))GENERAL ELECTRICAL SYSTEM61-0300 RELEASE TOOL

2013 Mini Cooper JCW, 2D Convertible, Standard Trans

61-0300 Release tool

2013 Mini Cooper JCW, 2D Convertible, Standard TransSECTION 61-0300 Release tool

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

0495382 610300 Release tool Minimum set: Measuring and testing equipment MP

NOTE: (release tool (set complete)) Replaces from 09/2005 special tool 61 1 150. From 06/2006 extended by tools 61 0 325 - 61 0 331 (see SI 02 05 06 294). From 02/2008 extended by 61 0 332 and 61 0 333 (see SI 02 03 08 440). [Released]

Storage Location

M22 x 205

SI number

02 05 05 (217)

Fig 1: Identifying Release Tool (0495382)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

0496333

0496332

0495680

0495678

0495677

0495676

0495578

0495407

0495406

0495405

0495404

0495403

0495401

0495400

0495399

0495398

0495397

0495396

0495395

0495394

0495391

0495389

0495387

0495385

0495383

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.