Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front
Necessary preliminary tasks:
- Remove top rear connection. See TOP REAR CONNECTION or TOP REAR CONNECTION (CONNECTION OF BOTH WHEEL ARCHES AT FRONT) .
Unclip clutch housing Bowden cable (1) at marked points.
Installation note:
Clips must not be damaged.
To open up clutch housing cover, lever up cover (2) in direction of arrow.
Feed rear Bowden cable (2) out of sliding carriage (1) and clutch housing (3).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.