Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER JCW, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3445 (MAINTENANCE AND GENERAL INFORMATION - REPAIR)GENERAL AND SAFETY INFORMATION00 00 612 SERVICE - FRONT BRAKESSERVICE - FRONT BRAKES
2013 Mini Cooper JCW, 2D Convertible, Standard Trans
Service - front brakes
2013 Mini Cooper JCW, 2D Convertible, Standard TransSECTION Service - front brakes
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Replace BRAKE PADS
.
- Replace the brake pad wear sensor
- Clean brake air ducts
- Apply a thin coating of grease to wheel centering on light alloy wheels
- BRAKE DISCS
- Check surface and thickness
- If necessary: Replace
- Reset CBS DISPLAY according to factory specification
NOTE:
- Replace brake discs when:
- Drop below the minimum brake disc thickness
- Scoring
- Heat cracks
- Thickness difference
- Issue a separate invoice for replacement of brake disc
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.