Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 270 Removing and installing/replacing switch for reversing light (DME)
Necessary preliminary tasks:
- If necessary, remove Rear Underbody Protection
Version A:
Disconnect plug connection (1).
Release switch for reversing light (2).
For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .
Version B:
Disconnect plug connection (1).
Release switch for reversing light (2).
For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.