2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment: Rear

WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If control arm-to-rear axle support nut is tightened down more than 10 times during adjustment, it must be replaced. Self-locking effect becomes too weak.
  1. Replace control arm-to-rear axle support nut (1) and tighten down. See Fig 1 . Release one half to one turn.
  2. Adjust toe-in using eccentric screw (3). Adjust precisely to specification. See WHEEL ALIGNMENT SPECIFICATIONSΒ  .
  3. Ensure that eccentric washer (2) is correctly located. Tighten control arm-to-rear axle support nut (1) to specification. See TORQUE SPECIFICATIONSΒ  .
Fig 1: Adjusting Rear Toe-In
G00302461Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.