Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Total Toe | |||||||||
| Front | .17° | 0 To .33° | |||||||
| Rear | .30° | .13 To .47° | |||||||
| Camber | |||||||||
| Front (1) | -.20° | -.37 To .20° | |||||||
| Rear (2) | -2° | -2.33 To -1.67° | |||||||
| Track Differential Angle With 20° Lock On Inside Wheel | -1.90° | -2.23 To -1.23° | |||||||
| Caster (3) | |||||||||
| With -10 To 10° Wheel Lock | 7.98° | ..... | |||||||
| With -20 To 20° Wheel Lock | 8.03° | ..... | |||||||
| Front Wheel Displacement | 0° | -.25 To .25° | |||||||
| Rear Geometrical Axis Deviation | 0° | -.2 To .2° | |||||||
| Maximum Wheel Lock | |||||||||
| Inside Wheel | 41.23° | ..... | |||||||
| Outside Wheel | 32.18° | ..... | |||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
