Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2006COOPER CONVERTIBLE (R52) L4-1.6L (W10)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGDESCRIPTION AND OPERATIONFUNCTIONAL DESCRIPTIONSTEMPERATURE CONTROL
2006 Mini Cooper Convertible (R52) L4-1.6L (W10)
Temperature Control
2006 Mini Cooper Convertible (R52) L4-1.6L (W10)SECTION Temperature Control
Temperature control
Temperature control IHKA: The required temperature in the passenger compartment is set by means of a rotary switch on the IHKA control panel and shown in the display.
Temperature control IHKR: The required temperature in the passenger compartment is set by means of a rotary switch on the IHKA control panel.
The interior, heat exchanger, evaporator, outside and coolant temperatures are evaluated for the purpose of temperature control together with the driving speed and engine speed signals.
The heating system operates based on the reheat principle. The air is cooled down by the evaporator and then heated up again to the required temperature by the heat exchanger. The rate of temperature increase is determined by the position of the temperature mixer flap. Based on its position, the temperature mixer flap controls the volumetric flow of warm or cold air.
Temperature mixer flap operation:
In the automatic air conditioning system (IHKA), the flap is adjusted by a stepper motor.
In the air conditioning system (IHKR) the flap is adjusted by means of a Bowden cable from the control panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.