Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
Key On/Engine Off Self-Test
- This is a static check of processor input and output circuits. Connect the STAR tester or VOM to vehicle Self-Test connector, making sure to connect VOM correctly. See Fig 1 . Turn ignition switch to "ON" position to start Self-Test. DO NOT depress throttle during test. Observe and record all On Demand and Continuous/Memory service codes.
- If any codes appear, refer to the proper test shown in the reference table for that specific engine. Start with the first code displayed. If the test refer you to other checks, perform them as instructed. When more than one code is displayed, repair problems in the order that codes are displayed.
NOTE:
When any repair has been completed, Quick Test MUST be repeated BEFORE attempting to repair any other problems identified by service codes. Proceed with repairs as indicated by KEY ON/ENGINE OFF SELF-TEST RESULTS
table and then by ON DEMAND CODES
table.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
