Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
EEC IV System
- Description
- Operation
- Testing & Diagnosis
- Diagnostic Procedure
- Key On/Engine Off Self-Test
- Computed Ignition Timing Check
- Engine Running Self-Test
- Continuous Self-Test
- Continuous Monitor (Wiggle) Test
- How To Use The Circuit Tests
- Preparation
- Reading Self-Test Codes
- Test Equipment
- Self-Test Connector Locations
- Equipment Hook-Up
- Diagnosis By Symptom Test
- Circuit Test A - No Start
- Circuit Test B - Vehicle Battery
- Circuit Test C - Reference Voltage
- Circuit Test D - Vane Air Temperature (Vat) Sensor
- Circuit Test G - Engine Coolant Temperature (ECT) Sensor
- Circuit Test H - Barometric Pressure (BP) Sensor
- Circuit Test I - Knock (Detonation) Sensor
- Circuit Test J - Throttle Position Sensor (TPS)
- Circuit Test K - Vane Airflow (VAF) Sensor
- Circuit Test M - Neutral Drive Switch-A/C Input
- Circuit Test N - Key Power Check
- Circuit Test O - Brake On/Off (Boo)
- Circuit Test Q - EFI Fuel Control
- Circuit Test V - Fuel Pump Circuit (Inertia Switch)
- Circuit Test W - EGR On/Off Check
- Circuit Test X - Air Management System
- Circuit Test Z - Idle Speed Control (By-Pass Air)
- Circuit Test GG - Wide Open Throttle A/C Cutoff (WAC) A/C Demand
- Circuit Test HH - Turbo Boost
- Circuit Test KK - Dynamic Response Test
- Circuit Test Ll - Ignition Diagnostic Monitor (IDM)
- Circuit Test Mm - Spark Timing Check
- Circuit Test NN - No Codes/Codes Not Listed
- Circuit Test Oo - Erratic Ignition
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.