Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2011MILAN AWD V6-3.0LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRREMOVAL AND REPLACEMENTFRONT SEATSEAT CUSHION COVER - FRONT
2011 Mercury Milan AWD V6-3.0L
Seat Cushion Cover - Front
2011 Mercury Milan AWD V6-3.0LSECTION Seat Cushion Cover - Front
Seat Cushion Cover - Front
Removal and Installation
1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.
2. NOTE: Trim cover J-clip configurations vary with seat option.
Release all the remaining J-clips attaching the trim cover to the cushion frame.
3. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.
Release the hook-and-loop strips, remove the hog rings (if equipped), separate the cushion trim cover from the cushion foam pad and remove.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.