Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accessory Protocol Interface Module (APIM) Programming
Accessory Protocol Interface Module (APIM) programming is a process that updates the APIMÂ Consumer Interface Processor (CIP) and Vehicle Interface Processor (VIP) software. The VIP programming updates the calibration files in the portion of the APIMÂ which interfaces with the Controller Area Network (CAN). The CIPÂ programming updates calibration files in the portion of the APIMÂ that interfaces with mobile phones and other customer devices.
APIMÂ programming uses the Vehicle Communication Module (VCM) to read and program the VIPÂ software through the Data Link Connector (DLC). A web-based On-Line Automotive Service Information System (OASIS) application is used to read and program the CIPÂ software via a Universal Serial Bus (USB) cable between the scan tool and vehicle USBÂ port. Both the VCMÂ and OASISÂ application must be running on the scan tool during APIMÂ programming. To carry out APIMÂ programming, refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMINGÂ in this service information.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.