Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ACCESSORY CONTROLS - COMPONENT TESTING - (EXCEPT HYBRID))
2010 Mercury Mariner Hybrid, AWD
Section 7 (Accessory Controls - Component Testing - (Except Hybrid))
2010 Mercury Mariner Hybrid, AWDSECTION Section 7 (Accessory Controls - Component Testing - (Except Hybrid))
WARNING: This page is about a different variant/trim than selected.
- Introduction
- Component Testing
- Main light switch
- Illumination dimmer switch (14A464)
- Ignition switch (14489)
- Multifunction Switch, Wiper/Washer Portion
- Master window control switch
- Window control switch, passenger side (14489)
- Window control switch, left rear (14489)
- Exterior rear view mirror switch (14A464)
- Power door lock switch
- Power seat switch, left
- Roof opening panel control switch
- Relay Mini ISO
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.