Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 17 (ENGINE CONTROLS - ELECTRONIC ENGINE CONTROLS - 3.0L (4V))SPECIFICATIONSTORQUE SPECIFICATION CHART
2010 Mercury Mariner Hybrid, AWD
Torque Specification Chart
2010 Mercury Mariner Hybrid, AWDSECTION Torque Specification Chart
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATION CHART
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Camshaft Position (CMP) sensor bolt | 10 | - | 89 | ||
| Catalyst Monitor Sensor (CMS) (1) | - | - | - | ||
| Crankshaft Position (CKP) sensor bolt | 10 | - | 89 | ||
| Cylinder Head Temperature (CHT) sensor | 11 | - | 97 | ||
| Heated Oxygen Sensor (HO2S) (1) | - | - | - | ||
| Knock Sensor (KS) | 48 | 35 | - | ||
| KS (block mounted) bolt | 25 | 18 | - | ||
| KS (cylinder head mounted) bolt | 25 | 18 | - | ||
| LH splash shield bolts | 10 | - | 89 | ||
| Manifold Absolute Pressure (MAP) sensor bolt | 6 | - | 53 | ||
| Mass Air Flow (MAF) sensor screws | 2 | - | 18 | ||
| PCM stud bolts | 8 | - | 71 | ||
| Variable Camshaft Timing (VCT) oil control solenoid bolts | 10 | - | 89 | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.