Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Knock Sensor (KS): Removal
2010 Mercury Mariner Hybrid, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
Cylinder head-mounted Knock Sensor (KS)
- Disconnect the Knock Sensor (KS) electrical connector.
- Remove the bolt and the KS
.
Engine block-mounted KS
- Remove the lower intake manifold. For additional information, refer to LOWER INTAKE MANIFOLD .
- Disconnect the KS electrical connector.
- Remove the bolt and the KS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.