Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (AUTOMATIC TRANSMISSION - 6F35)SPECIFICATIONSSOLENOID OPERATION CHART
2010 Mercury Mariner Hybrid, AWD
Solenoid Operation Chart
2010 Mercury Mariner Hybrid, AWDSECTION Solenoid Operation Chart
WARNING: This page is about a different variant/trim than selected.
SOLENOID OPERATION CHART
| Base Selector Lever Position | PCM Commanded Gear | Shift Solenoid | TCC (VFS) NL | ||||||
|---|---|---|---|---|---|---|---|---|---|
| SSA (VFS) NL (CB 1, 2, 3, 4) | SSB (VFS) NH (3, 5, R) | SSC (VFS) NL (CB 2, 6) | SSD (VFS) NH (CB L, R/C 4, 5, 6) | SSE (On/Off) NC | |||||
| P | P | Off | On | Off | On | On | Off | ||
| R | R | Off | Off | Off | Off | On | Off | ||
| N | N | Off | On | Off | On (1) | On (1) | Off | ||
| D | 1 | On | On | Off | On | On | Off | ||
| 2 | On | On | On | On | Off | Off | |||
| 3 | On | Off | Off | On | Off | Off | |||
| 4 | On | On | Off | Off | Off | On/Off | |||
| 5 | Off | Off | Off | Off | Off | On/Off | |||
| 6 | Off | On | On | Off | Off | On/Off | |||
| L | L | On | On | Off | Offb | On | Off | ||
| CB = Clutch brake NC = Normally closed NH = Normally high NL = Normally low |
|||||||||
|
|||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.