General Specifications

2010 Mercury Mariner Hybrid, AWDSECTION General Specifications
WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATIONS

Item Specification
Transmission FluidΒ 
The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage. Refer to the material specification for the correct transmission fluid.
NOTE: Do not use water-based cleaners to clean or flush the transmission fluid cooler tubes or transaxle damage will occur. Mineral spirits can be used to clean the transmission fluid cooler tubes, providing the transmission fluid cooler tubes are flushed with clean transmission fluid and blown dry with shop air. Use only clean transmission fluid designated for this transaxle and torque converter being serviced.


GENERAL SPECIFICATIONS

Item Specification
Transaxle Weight 86 kg (189 lb)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.