Digital Transmission Range (TR) Sensor: Removal

All vehicles 

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING -- ESCAPE, ESCAPE HYBRID, MARINER & MARINER HYBRID .

   3.0L engine 

2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - 3.0L (4V) .

   2.5L engine 

3. Remove the ACL  outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - 2.5L .

   All vehicles 

4. Remove the retainers and the LH splash shield.
   Fig 1: Locating LH Splash Shield Retainers

   Courtesy of FORD MOTOR CO.

   3.0L engine 

5. Remove the retainers and the RH splash shield.
   Fig 2: Locating RH Splash Shield Retainers

   Courtesy of FORD MOTOR CO.

   All vehicles 

6. Remove the transmission fluid drain plug and allow the transmission fluid to drain.
   Fig 3: Locating Transmission Fluid Drain Plug

   Courtesy of FORD MOTOR CO.
7. Install the transmission fluid drain plug.
   • Tighten to 12 Nm (106 lb-in).
     Fig 4: Locating Transmission Fluid Drain Plug

     Courtesy of FORD MOTOR CO.

   3.0L engine 

8. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in ENGINE COOLING .
9. Disconnect the upper radiator hose from the coolant pump housing and position it aside.
10. Disconnect the lower radiator hose from the thermostat housing and position it aside.

    All vehicles 

11. Disconnect the selector lever cable end from the manual control lever.
    Fig 5: Disconnecting Selector Lever Cable End From Manual Control Lever

    Courtesy of FORD MOTOR CO.
12. Remove the nut and the manual control lever.
    Fig 6: Locating Manual Control Lever Nut

    Courtesy of FORD MOTOR CO.
13. Disconnect the transaxle vehicle harness electrical connector.
    Fig 7: Locating Transaxle Vehicle Harness Electrical Connector

    Courtesy of FORD MOTOR CO.
14. Remove the transaxle electrical wiring harness retainers from the transmission fluid pan stud bolts.
    Fig 8: Locating Transaxle Electrical Wiring Harness Retainers

    Courtesy of FORD MOTOR CO.
15. Remove the transmission fluid cooler tube bracket nuts from the main control cover studs and position the transmission fluid cooler tubes and bracket aside.
    Fig 9: Pulling Transmission Fluid Cooler Tube Bracket And Tubes From Transaxle

    Courtesy of FORD MOTOR CO.
NOTE: Note the location of the stud bolts for assembly.