Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Park Component Exploded View
2010 Mercury Mariner Hybrid, AWDSECTION Park Component Exploded View
WARNING: This page is about a different variant/trim than selected.
PARTS DESCRIPTION CHART
| Item | Part Number | Description |
|---|---|---|
| 1 | W714437 | Transmission Range (TR) sensor detent spring bolt |
| 2 | 7E332 | TR sensor detent spring |
| 3 | 7G100 | Manual shaft-to- TR sensor pin |
| 4 | 7A232 | Park pawl actuator rod |
| 5 | 7H557 | TR sensor |
| 6 | 7C493 | Manual shaft |
| 7 | 7A256 | Manual lever |
| 8 | 7F337 | Manual shaft seal |
| 9 | W302864 | Manual lever nut |
| 10 | 7A441 | Park pawl |
| 11 | 7D071 | Park pawl pin |
| 12 | 7D070 | Park pawl spring |
| 13 | 7005 | Transaxle case |
| 14 | 7090 | Park gear |
| 15 | 7G132 | Drive chain drive sprocket |
| 16 | 7C122 | Drive sprocket snap ring |
| 17 | 7G099 | No. 13 thrust washer |
| 18 | 7G355 | No. 12 thrust bearing |
| 19 | 7G132 | Drive chain driven sprocket |
| 20 | 7F342 | Final drive planetary gearset sun gear |
| 21 | 7F465 | Final drive planetary carrier/differential assembly |
| 22 | 7C122 | Final drive planetary ring gear snap ring |
| 23 | 7F343 | Final drive planetary ring gear |
| 24 | 7G249 | Drive chain |
| 25 | 7975 | Torque converter housing |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.