Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Continuous Memory Self-Test
The continuous memory self-test is a functional test of the PCM carried out under any condition (engine running or off) with the key on. Unlike the KOEO and KOER self-tests, which can only be activated on-demand, the continuous self-test is always active. A concern does not need to be present when accessing continuous memory self-test DTCs, making the test valuable when diagnosing intermittent concerns. The vehicle may need to be driven or the on board diagnostic (OBD) drive cycle completed to allow the PCM to detect a concern. Refer to ON BOARD DIAGNOSTIC (OBD) DRIVE CYCLE for more information. When a concern is stored in memory, a DTC is output on the data link when requested by the scan tool.
There are two types of continuous DTCs. The first type is an emission-related code which illuminates the malfunction indicator lamp (MIL) in the instrument cluster. The second is a non-emission related, non-MIL code which does not illuminate the cluster indicator.
For emission-related MIL codes, the PCM stores the DTC in continuous memory when a concern is detected for the first time. At this point the DTC does not illuminate the MIL and is now considered a pending code. The purpose of pending codes is to assist in repair verification by reporting a pending DTC after one drive cycle. If the same concern is detected after the next ignition start-run cycle, the emission-related MIL code illuminates the MIL. The MIL remains on even if the concern is intermittent. The MIL is extinguished if the concern is not present through 3 consecutive drive cycles or if the concern is fixed and the DTCs are cleared. Also, an emission-related pending MIL and any non-emission related, non-MIL DTCs are erased after approximately 40 vehicle warm-up cycles or if the DTCs are cleared.
Any scan tool that meets OBD requirements can access the continuous memory to retrieve emission-related MIL DTCs. However, not all scan tools access pending and non-emission related, non-MIL DTCs in the same way.
During most diagnostic procedures in this article, it is required that all DTCs be retrieved and cleared. Consult the instruction article from the tool manufacturer for specific instructions.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.