Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 968 (CRUISE CONTROL SYSTEM)REMOVAL AND INSTALLATIONSPEED CONTROL ACTUATORREMOVAL
2010 Mercury Mariner Hybrid, AWD
Speed Control Actuator: Removal
2010 Mercury Mariner Hybrid, AWDSECTION Removal
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Press the locking tab and rotate the speed control cable cap to remove.
- Disconnect the speed control cable from the speed control actuator pulley.
- Gently push the retaining spring.
- Disconnect the speed control cable slug from the speed control actuator pulley.
- Remove the 3 speed control actuator screws and the speed control actuator.
- Disconnect the electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.