Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 947 (WARNING SYSTEM)DIAGNOSTIC TESTSWARNING DEVICESINSPECTION AND VERIFICATION
2010 Mercury Mariner Hybrid, AWD
Inspection and Verification
2010 Mercury Mariner Hybrid, AWDSECTION Inspection and Verification
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect the following for obvious signs of electrical damage.VISUAL INSPECTION CHART
Electrical - Circuitry
- Key-in-ignition switch (part of the ignition switch)
- Instrument cluster
- Smart junction box (SJB)
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
- If the scan tool does not communicate with the VCM:
- Check the VCM connection to the vehicle.
- Check the scan tool connection to the VCM.
- Refer to MODULE COMMUNICATIONS NETWORK article, No Power To The Scan Tool, to diagnose no communication with the scan tool.
- If the scan tool does not communicate with the vehicle:
- Verify the ignition key is in the ON position.
- Verify the scan tool operation with a known good vehicle.
- Refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the powertrain control module (PCM).
- Carry out the network test:
- If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK article.
- If the network test passes, retrieve and record the continuous memory DTCs.
- Clear the continuous DTCs and carry out the self-test diagnostics for the SJB.
- If the DTCs retrieved are related to the concern, go to the Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Index. For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES article.
- If no DTCs related to the concern are retrieved, go to Symptom Chart .
NOTE:
Make sure to use the latest scan tool software release.
NOTE:
The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Action |
|---|---|---|
| B1352 | Ignition Key-In Circuit Failure | Go to Pinpoint Test A . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES article. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.