Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 900 (AUTOMATIC TRANSMISSION - CD4E)DISASSEMBLYTRANSAXLENOTES
2010 Mercury Mariner Hybrid, AWD
Section 900 (Automatic Transmission - Cd4E): Disassembly: Transaxle: Notes
2010 Mercury Mariner Hybrid, AWDSECTION Notes
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Actuator Pin (Dia 3/16 Inch) | 303-D011 (D80L-100-G) | |
| Collet, 3/4 to 7/8 Inch | 303-D019 (D80L-100-Q) | |
| Cross Block | 307-109 (T81P-78103-A) | |
| Handle, Torque Converter | 307-091 (T81P-7902-C) | |
| Holding Fixture, Transmission | 307-003 (T57L-500-B) | |
| Holding Fixture, Transmission | 307-288 (T94P-77000-F) | |
| Remover, Input Shaft Oil Seal | 308-375 | |
| Remover/Installer, Servo Cover | 307-295 (T94P-77000-L) | |
| Remover, RH Halfshaft Fluid Seal | 307-429 | |
| Remover, Transmission Fluid Pump | 307-289 (T94P-77000-G) | |
| Retainer, Torque Converter | 307-346 (T97T-7902-A) | |
| Slide Hammer | 100-001 (T50T-100-A) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.