SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 900 (AUTOMATIC TRANSMISSION - CD4E)DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESCHAIN SPROCKETSASSEMBLY
2010 Mercury Mariner Hybrid, AWD

Chain Sprockets: Assembly

2010 Mercury Mariner Hybrid, AWDSECTION Assembly
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the No. 16 reverse/overdrive ring gear bearing on the special tools.
    • Position the bearing with the part number facing toward the handle of the special tool.
    2. Fig 1: Positioning No 16 Reverse/Overdrive Ring Gear Bearing On Special Tools
    GF0024942Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.