Torque Of Motor-AC (TMAC) Signal

The TCM calculates an AC traction motor torque from an AC current measured by the current sensor which is located inside the transaxle. The TMAC is a 50% duty cycle signal which the TCM sends to the PCM using the TMAC circuit. TCM also broadcasts a redundant traction motor torque message to the PCM over the communication link. The typical TMAC signal ranges from 200 Hz to 400 Hz, where 300 Hz is equal to 0 Nm (0 lb ft) of torque, 200 Hz is equal to 250 Nm (185 lb ft) of negative torque, and 400 Hz is equal to 250 Nm (185 lb ft) of positive torque. Positive torque is perceived as vehicle acceleration and negative torque is perceived as braking. The PCM uses the traction motor torque value as an input to the energy management control strategy, the torque monitor strategy, and the regenerative brake torque limits strategy. In the event of TMAC circuit failure the PCM initiates limited operating strategy (LOS) shutdown mode which disables the vehicle. The PCM also stores an appropriate DTC.