Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clean Tachometer Output (CTO)
The PCM uses a crankshaft position (CKP) sensor input to calculate the engine speed. The engine speed information is then output to the transaxle control module (TCM) through the CTO circuit, as a frequency signal. The PCM also broadcasts a redundant engine speed message to the TCM over the controller area network (CAN) communication link. When the broadcasted engine speed disagrees with the hardwired CTO signal, or when the CTO circuit concern condition is detected, the TCM stores an appropriate diagnostic trouble code (DTC).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.