Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accelerator Pedal Position (APP) Sensor
The APP sensor is an input to the powertrain control module (PCM) and is used to determine the torque demand. There are 3 pedal position signals in the sensor. Signal 1, APPS1, has a negative slope (increasing angle, decreasing voltage). Signals 2 and 3, APPS2 and APPS3, both have a positive slope (increasing angle, increasing voltage). During normal operation APPS1 is used as the indication of pedal position by the strategy. The 3 pedal position signals make sure the PCM receives a correct input even if a signal has a concern. There are 2 reference voltage circuits and 2 signal return circuits for the sensor. For additional information, refer to TORQUE BASED ELECTRONIC THROTTLE CONTROL (ETC) .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.