Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intermediate Shaft Speed Sensor
The intermediate shaft speed sensor is located in the transmission housing over the transmission intermediate shaft.
The intermediate shaft speed sensor is an inductive sensor which senses the speed of rotation of the transmission input shaft.
The signal is used for the following functions:
- To determine the shift timing.
- To control the shift operations.
- To control the torque converter clutch.
If the intermediate shaft speed sensor fails, the signal of the output shaft speed and turbine shaft speed sensors is used as a substitute signal.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.