Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 608 (ELECTRONIC ENGINE CONTROLS - 2.3L)SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
Torque Specifications
2010 Mercury Mariner Hybrid, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Camshaft position (CMP) sensor bolt | 7 | - | 62 | ||
| Crankshaft position (CKP) sensor bolts (1) | - | - | - | ||
| Cylinder block plug | 20 | 15 | - | ||
| Cylinder head temperature (CHT) sensor | 12 | 9 | - | ||
| Heated oxygen sensors (HO2S) and catalyst monitor sensors (CMS) | 48 | 35 | - | ||
| Knock sensor (KS) bolt | 20 | 15 | - | ||
| Mass air flow (MAF) sensor screws | 2 | - | 18 | ||
| Powertrain control module (PCM) bolts | 8 | - | 71 | ||
| Variable camshaft timing (VCT) oil control solenoid bolt | 10 | - | 89 | ||
| Manifold absolute pressure (MAP) sensor screw | 3 | - | 27 | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.