Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 530 (HVAC CONTROL SYSTEM)REMOVAL AND INSTALLATIONIN-VEHICLE TEMPERATURE SENSORREMOVAL AND INSTALLATION
2010 Mercury Mariner Hybrid, AWD
Removal and Installation
2010 Mercury Mariner Hybrid, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument cluster finish panel. For additional information, refer to REMOVAL AND INSTALLATION .
- Remove the 3 lower steering column cover screws.
- Remove the lower steering column cover.
- Remove the 3 lower steering column shroud screws.
- Remove the lower steering column shroud.
- Disconnect the in-vehicle temperature sensor electrical connector.
- Remove the in-vehicle temperature sensor.
- To install, reverse the removal procedure.
Five Hundred/Montego
Freestyle
All vehicles
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.