Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 402 (ELECTRONIC ENGINE CONTROL SYSTEM - 3.0L (4V))SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
Torque Specifications
2010 Mercury Mariner Hybrid, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Camshaft position (CMP) sensor bolt | 10 | - | 89 |
| Catalyst monitor sensor | 48 | 35 | - |
| Crankshaft position (CKP) sensor bolt | 10 | - | 89 |
| Heated oxygen sensor (HO2S) | 48 | 35 | - |
| Fuel rail pressure and temperature sensor bolts | 4 | - | 35 |
| Idle air control (IAC) valve bolts | 10 | - | 89 |
| Manifold absolute pressure (MAP) sensor nut | 9 | - | 80 |
| Mass air flow (MAF) sensor | 7 | - | 62 |
| Powertrain control module stud bolts and nuts | 9 | - | 80 |
| RH splash shield bolts | 9 | - | 80 |
| LH splash shield bolts | 10 | - | 89 |
| Throttle position (TP) sensor screws | 3 | - | 27 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.