Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 395 (HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS)GENERAL PROCEDURESAUTOLOCK AND HORN CHIRP PROGRAMMINGUSING THE KEYLESS ENTRY KEYPAD (IF EQUIPPED)
2010 Mercury Mariner Hybrid, AWD
Using the Keyless Entry Keypad (If Equipped)
2010 Mercury Mariner Hybrid, AWDSECTION Using the Keyless Entry Keypad (If Equipped)
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A manual enable/disable mode allows the autolock feature to be turned off and on.
- Enter the 5-digit permanent entry code into the keyless entry keypad.
- Within 5 seconds of entering the code, press and hold the 7/8 button on the keypad.
- Within 5 seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.
- Within 5 seconds of Step 3, release the 7/8 button on the keypad.
NOTE:
If the autolock is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly and then sounds a second time for a longer sound of the horn once the above sequence is completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.