Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 308 (FULL FRAME AND BODY MOUNTING)SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
Torque Specifications
2010 Mercury Mariner Hybrid, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Brake caliper bolts | 32 | 24 | - |
| Body mount bolts (all others) | 48 | 35 | - |
| Engine mount nuts | 90 | 66 | - |
| Front end body mount bolts | 55 | 41 | - |
| Front end body mount nuts | 48 | 35 | - |
| Intermediate shaft bolt | 30 | 22 | - |
| Lower control arm rear mounting bolts | 90 | 66 | - |
| Number 2 crossmember bolts | 250 | 184 | - |
| Number 2 crossmember bracket bolts | 103 | 76 | - |
| Number 2 crossmember bracket nuts | 200 | 148 | - |
| Outer tie rod end nuts | 80 | 59 | - |
| Stabilizer bar link nuts | 63 | 46 | - |
| Steering gear nuts | 103 | 76 | - |
| Steering gear studs | 20 | 15 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.